Workers plug Alaska North Slope oil well that leaked gas

By The Associated Press

An oil well leaking natural gas on Alaska's North Slope was successfully plugged by pumping saltwater into the well, according to private and government responders.

This April 2017 photo provided by the U.S. Environmental Protection Agency shows an oil well that was misting natural gas on Alaska's frozen North Slope. Workers from the Alaska Department of Conservation and the Environmental Protection Agency on Saturday, April 15, 2017, were able to connect hoses to valves that allow pressure in the well to be reduced, according to a statement from the state conservation department. The Environmental Protection Agency says a crack in the BP wellhead near Deadhorse sent up mist of crude oil Friday before it froze over and an initial leak stopped. (U.S. Environmental Protection Agency via AP)

ANCHORAGE, Alaska (AP) — An oil well leaking natural gas on Alaska's North Slope was successfully plugged by pumping saltwater into the well, according to private and government responders.

The state Department on Environmental Conservation on Monday said the well operated by BP Exploration Alaska Inc., a subsidiary of BP, was "killed" at 3:35 a.m.

The well is five miles from the airport at Deadhorse. Employees on Friday morning discovered uncontrolled natural gas flowing from the top of a well house, a metal structure that looks like a large box over a well.

About 45 minutes later, they determined that the well was spraying a mist of crude oil into the air.

BP reported the leak and set up a joint response team with state, federal and municipal responders.

A weekend statement from the "unified command" said two leaks were detected. Oil was spraying from a leak near the top of the well. Workers contained that leak by activating a safety valve.

Oil droplets likely were contained to 1.5 acres (0.61 hectares) of the drill pad, responders said. They were waiting for the well to be plugged to determine if oil reached nearby snow-covered tundra.

Responders determined the well had risen up to 4 feet (1.22 meters) causing a pressure gauge to break off and preventing responders from pumping material into the well to kill it.

Responders on Saturday night were able to enter the well house and connect hoses to valves. That allowed the bleeding off of gas from space around the well's below-ground piping and a reduction in gas pressure.

Responders from Boot and Coots Services, a well-control contractor, entered the well house and placed a plug in the above-ground piping. That allowed responders to pump in a solution of methanol and saltwater, killing the well.

The temperature at the site Monday was 21 degrees F (-6.11 Celsius).

The nearest village, Nuiqsut (noo-IK-sit), is 50 miles (80.46 kilometers) away.

Did You Like this Article? Get All the Energy Industry News Delivered to Your Inbox

Subscribe to an email newsletter today at no cost and receive the latest news and information.

 Subscribe Now

Whitepapers

Selection, Use, Care and Maintenance of FR Clothing

For industries operating in an inherently dangerous environment, the importance of selecting the ...

Evolution or Revolution: IT / OT convergence means a world of possibilities

The oil and gas industry is experiencing a rapid paradigm shift in regards to digital transformat...

Predict, Prescribe, Profit: Creating a World that Doesn't Break Down

What are you doing to reduce unplanned downtime at your plant? Equipment breakdowns and process i...

A Traders Guide to Analysis and Research

An e-book dedicated to helping you improve your analysis by looking at RBOB futures performance. ...

Latest PennEnergy Jobs

PennEnergy Oil & Gas Jobs