OTC 2012: FCI flow meter can be calibrated on location

Offshore staff

HOUSTON – The VeriCal In-Situ Calibration Verification System now is available in Fluid Components International’s ST100 Series Thermal Mass Flow Meter, and will be demonstrated at OTC 2012.

The meter and calibration system are designed to comply with 30 CFR Part 250, Subpart K, Section 250 that says domestic US offshore facilities processing more than 2,000 b/d of oil must have flare/vent gas flow meters.

The system allows for verification of meter calibration without removing the meter from its place in the processing system. No trip to a lab is needed, either, obviously.

The ST100 stores as many as five unique calibration groups to accommodate broad flow ranges, differing mixtures of the same gas and multiple gases, and obtains up to 1000:1 turndown. 

The ST100 also can migrate to work with 4.20 mA analog, frequency/pulse, alarm relays, or digital bus communications if needed by changing out a plug-in card on location.

Diagram shows how the Veri-Cal system works.

VeriCal In-Situ Calibration Verification System

Did You Like this Article? Get All the Energy Industry News Delivered to Your Inbox

Subscribe to an email newsletter today at no cost and receive the latest news and information.

 Subscribe Now

Whitepapers

Maximizing Operational Excellence

In a recent survey conducted by PennEnergy Research, 70% of surveyed energy industry professional...

Leveraging the Power of Information in the Energy Industry

Information Governance is about more than compliance. It’s about using your information to drive ...

Reduce Engineering Project Complexity

Engineering document management presents unique and complex challenges. A solution based in Enter...

Revolutionizing Asset Management in the Electric Power Industry

With the arrival of the Industrial Internet of Things, data is growing and becoming more accessib...